MT75 Transmission

MT75 Transmission equips with TRANSIT of 4JA1 Engine

 

Transmission Ratios

Capacity
Description	Litres
Transmission fluid	1,2
Oil level	0 - 5 mm below lower edge of check bore

Engine	1st gear	2nd gear	3rd gear	4th gear	5th gear	Reverse gear
2,0 DOHC 8V	3,89	2,08	1,34	1,00	0,82	3,51
2,0 DOHC 16V	3,61	2,08	1,44	1,00	0,83	3,26
2,3 DOHC 16V	3,61	2,08	1,44	1,00	0,83	3,26
MY to '97
2,3 DOHC 16V	3,61	2,08	1,36	1,00	0,76	3,26
MY '98 on
2,5l TCI Diesel	3,61	2,08	1,36	1,00	0,76	3,26

     

Torques
General	Nm	lbf.ft
Engine undershield to front axle crossmember	19	14
Rear axle transverse brace	49	36
Front axle transverse brace	80	59
Coolant expansion tank (2,5 TCI)	5	4
Exhaust	Nm	lbf.ft
Exhaust manifold heat shield (2,0 DOHC 8V)	7	5
Catalytic converter to exhaust manifold (2,0 DOHC 8V)	41	30
Front exhaust pipe to turbocharger (2,5 TCI)	45	33
Catalytic converter to exhaust mounting bracket	47	35
Exhaust mounting bracket to transmission	44	32
Exhaust mounting bracket to transmission crossmember	47	35
Front to rear part of exhaust system	47	35
Turbocharger heat shield (2,5 TCI)	10	7
Turbocharger heat shield (2,5 TCI)	12	9
Clutch	Nm	lbf.ft
Clutch pressure plate to flywheel	30	22
Slave cylinder (complete with release bearing)	10	7
Bolt for hydraulic clutch pipe (2,5 TCI)	44	32
Master cylinder	10	7
Pressure pipe to master cylinder	14	10
Bleed nipple	14	10
Driveshaft	Nm	lbf.ft
Driveshaft to rear axle vibration damper	66	49
Driveshaft centre bearing to floor assembly	21	15
Driveshaft to transmission	78	58
Remove/install transmission	Nm	lbf.ft
Starter motor (2,0 DOHC 8V)	44	32
Starter motor and heat shield to transmission intermediate flange (2,5 TCI)
	35	26
Heat shield bracket to starter motor (2,5 TCI)	12	9
Engine/transmission flange bolts	44	32
Transmission mounting bracket bolts (2,5 TCI)	44	32
Adaptor plate to transmission	11	8
Gearshift support bracket to transmission	11	8
Oil dipstick bracket	10	7
Transmission crossmember to floor assembly	36	27
Transmission crossmember to transmission	62	46
Dismantle/assemble transmission	Nm	lbf.ft
Mainshaft ball bearing retaining bolts	24	18
Gearshift gate to transmission housing	10	7
Front transmission housing to rear transmission housing	24	18
Reverse gear idler shaft to transmission housing	32	24
Reversing light switch	33	24
Locking plate locking screw to transmission housing	14	10
Threaded plug of selector shaft detent mechanism	24	18
Drive flange to mainshaft (nut can only be used once)	200	148
Input shaft guide sleeve	250	184
Countershaft bearing housing, stage 1	30	22
Countershaft bearing housing, stage 2 (loosen)	-80ø	-80ø
Countershaft bearing housing, stage 3 (tighten)	20ø	20ø
Countershaft bearing housing, minimum	6	4
Fixture of locking plate for bearing housing	25	18
Oil drain and filler plugs

MT75 Transmission